Baumatic BHG602TCSS Instrukcja Użytkownika Pobierz pdf (Strona 17)

o Place the clamp (B) over the holes that match the size of the

screws. There are one set of screw holes in each corner of the

hob. Slightly tighten a screw (C) through the clamp (B) so that

the clamp is attached to the hob, but so that you can still adjust

the position of it.

o Carefully turn the hob back over and then gently lower it into the

aperture hole that you have cut out.

o On the underneath of the hob, adjust the clamps into a position

that is suitable for your worktop. Then fully tighten the screws

Gas connection

nts.

This appliance must be installed by a competent

person in accordance with the current versions of

the following UK (United Kingdom) or ROI (Republic

of Ireland) Regulations and Safety Standards or

their European Norm Replaceme

Important information

o This cooker is supplied to run on natural gas only and cannot

be used on any other type of gas without modification.

o Conversion for use on LPG and other gases must only be

undertaken by a qualified person. For information on the use of

other gases, please contact the Baumatic Technical Department.

o The cooker must be installed by a qualified person, in

accordance with the current edition of the Gas Safety

(Installation and Use) (Amendment) Regulations and the

relevant building/I.E.E. Regulations.

o Failure to install the appliance correctly could invalidate

Baumatic’s guarantee and lead to prosecution under the

regulations quoted above.

o In the UK, CORGI registered installers are authorised to

undertake the installation and service work, in compliance with

the above regulations.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Brak uwag

Baumatic BHG602TCSS Instrukcja Użytkownika Strona 17