Baumatic BHI625 Instrukcja Użytkownika

1 BHI625 60cm Induction hob with slider

10 Electrical details Rated Voltage: 220 - 240 Vac 50 - 60 Hz Supply Connection: 30 A (double pole switched fused outlet with 3mm cont

11 Control panel layout 1) Cooking zone selection buttons 2) Timer button 3) Slider control 4) Booster button 5) Safety lock button 6) O

12 Touch controls o All operations are performed by means of the touch controls that can be found on the control panel. o The controls respon

13 Switching on a zone and setting a power level IMPORTANT: A zone must be selected within 1 minute of turning the hob on. o Make sure that the b

14 o No heating will take place unless there is a suitable pan on the cooking zone. The display will automatically turn off after 2 minu

15 o An “H” symbol will show in the cooking zone indicator until the surface has cooled down to a safe temperature (see the se

16 approximately every few seconds. If no pan is detected after 2 minutes the hob will automatically switch off o You should check tha

17 o The boost function will operate the chosen cooking zone at maximum power for 5 minutes. After this time, the cooking zone will return

18 o When the required countdown time is shown in the display, release all controls. The display will show the remaining time bef

19 o Press the timer button again and the “1” digit will flash. o Set the required countdown time using the slider control. As you sli

2 User Manual for your Baumatic BHI625 60 cm Induction hob with slider NOTE: This User Instruction Manual contains import

20 WARNING: If any other cooking zones are in use, without a countdown timer set, they will continue heating. You will need to switch

21 o If the hob is switched off using the ON/OFF button while the safety lock is activated, the safety lock will still be acti

22 o When cold, the bottom of the pans should be slightly concave, as they expand when hot and lie flat on the surface of the hob. This will allow

23 Although it is easier to clean some deposits whilst the hob surface is still warm. You should take care not to burn yourself if cleanin

24 o The ceramic surface should be wiped with a damp cloth and a small amount of washing up liquid. o Dry the appliance by rubbing the

25 o If the hob is positioned so that the right or left hand side of the appliance will be near to the edge of a kitchen unit. There must be a gap

26 Installing the appliance o Cut a hole in the worktop that corresponds with the drawing shown above. o IMPORTANT

27 o Carefully lower the hob into the aperture hole that you have cut out. o There are holes on the base of the hob that you

28 o The spur outlet must still be accessible even when your hob is located in its operating position. o Cable type: H05 RRF 3 core x

29 Replacing the mains supply cable If the mains supply cable is damaged, then it must be replaced by an appropriate replacement. The mains supp

3 Contents Environmental note 4 Important safety information 5 – 8 Specifications 9 – 11 Product and aperture

30 o The residual heat indicator has not come on after I have switched a cooking zone off. * The cooking zone has only been turned on f

31 and contact the Customer Care Helpline. DO NOT continue to use the appliance. IMPORTANT: If your appliance appears not to be op

32 Baumatic Consumables o BC001 Degreaser for Dishwashers (200 g) o BC002 Descaler for Washing Machines and Dishwashers (200 g) o BC003 Ceram

33 United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sal

34

35

36

4 Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please dis

5 Important safety information Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet

6 Child Safety o Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowed

7 o IMPORTANT: This ceramic induction hob fully complies with current legislation regarding electro-magnetic interference and is desig

8 Declaration of conformity This appliance complies with the following European Directives: -2006/95/CE General regulations / Low tension -1935/20

9 Specifications Product dimensions: Aperture dimensions: Depth: 520 mm Depth: 495 mm Width: 590 mm Width: